A low newel post is a peril for taller visitors to our home so I tend to dangle seasonal ‘creations from it to avoid bumps. This month’s version uses one of my less used die sets.
The pirate ship die alone is 4 inches square (about 10.5 cm) so works well as part of a dangler.
Each element from the set was cut from card two or three times and stuck together to give it some stability and to sandwich in the thread hanger. I tried to use most of this fun Docrafts die set but couldn’t quite work the palm tree, desert island or octopus into this version. Next time maybe.
Precisely cut cards using my stash of lovely papers
The ‘hello’ card was made with 7 equal squares and one double size from assorted papers with little motifs from the scan n cut library to embellish them. The card base was dry embossed at half inch intervals and then the panels mounted on fun foam and then adhered in place.
I found it easiest to position the small corner pieces first , then the large piece and then centring the remaining pieces afterwards. The embossing helped with alignment
For the baby card I used the Docrafts papermania pastels craft collection paper. I covered the card base with the small hearts paper, stuck a strip of the large icons paper centrally over it and then cut words in different fonts from brown card for the greeting.
Inside I stuck two hearts and a footer strip from complementary papers from the pad – keeping towards the blue tones. To finish I brushed the greeting with Wink of Stella glitter.
I need to use some of my lovely Christmas papers so made up the set of cutlery pouches as a gift for someone I know likes the concept.
I used the docrafts folk Christmas kit. This included sheets of stick on initials.
Method: a 12 x 12 sheet is cut into three strips, each 4 inches wide. Each strip is folded at 8 inches to create a front flap half the height of the back. The sides of the pouch are stuck down with thin double sided tape
A belly band is created by cutting a 1 inch strip from some contrast paper, the strip wrapped round the pouch and fixed with double sided tape
A square (with corners rounded) of scrap paper is stuck over the join in the belly band and an initial stuck on the square
I used border patterns from my scan n cut to give top and bottom of each sheet a scallop edge but a border punch or pinking scissors would also work.
Four sheets of paper made nine pouches including belly bands and trim and a set of spare initials was included to cater for a range of guests.
but when trimming a piece of ikea fleece to protect the dog’s new favourite snooze seat, the wavy edge made a simple rectangle just that bit smarter – and it cut the fleece like butter and better than with scissors